sgichk_cisco_chassis

Working Properly. Below is my output.
#########################################
./sgichk_cisco_chassis.pl -H 192.168.1.1 -C public
OK: All Environmental Sensors ok
Switch#1, Fan#1 = Normal
Sw1, PS1 Normal, RPS NotExist = Normal
#########################################
./sgichk_cisco_chassis.pl -H 192.168.1.2 -C public
OK: All Environmental Sensors ok
chassis = Normal
chassis = Normal
internal power supply = Normal
redundant power supply = notPresent
#########################################
./sgichk_cisco_chassis.pl -H 192.168.1.3 -C public
OK: All Environmental Sensors ok
Switch#1, Fan#1 = Normal
Sw1, PS1 Normal, RPS NotExist = Normal
#########################################

Getting it installed was no issue, but when I run the plugin in terminal, I get this:

"ERROR fetching Envmon table: The requested table is empty or does not exist"

I am using an ASA 5512-X. Does that mean the plugin is not compatible with the device, or have I mis-configured?

Hi all,

I can't wait to get this plugin working!, but for some reason (I can't get it working). I am assuming user error as it works via terminal. I set it to be executable, and I get a

(Return code of 127 is out of bounds - plugin may be missing) in nagios.

I have declared it in switch.cfg as:

#cisco Chassis temperature
define service{
use generic-service
host_name VPU Core
service_description Cisco Temps
check_command sgichk_cisco_chassis!-C read
}

I have declared it in commands.cfg as:
# 'check_enviro' command definition
define command{
command_name sgichk_cisco_chassis
command_line $USER1$/sgichk_cisco_chassis! -H $HOSTADDRESS$ $ARG1$
}

When I run it via terminal I get:

libexec# ./sgichk_cisco_chassis.pl -H 192.168.2.16 -C read
OK: All Environmental Sensors ok
SW#1, Sensor#1, GREEN = 31 = Normal
SW#2, Sensor#1, GREEN = 30 = Normal
Switch#1, Fan#1 = Normal
Switch#1, Fan#2 = Normal
Switch#2, Fan#1 = Normal
Sw1, PS1 Normal, RPS NotExist = Normal
Sw1, PS2 Normal, RPS NotExist = Normal
Sw2, PS1 Normal, RPS NotExist = Normal
Sw2, PS2 Normal, RPS NotExist = Normal
I am sorry. It looks like a great plugin, I just can't figure out how to get it to work. I would like to get it to report on each switch, in nagios 3.3.1. I don't see any specific documentation on how to use it.